China Suppliers Factory Wire Trim Edge Cutting Tape for Powder Spray Trimming - Polyester Double Sided PET Tape
| Applications | Trim coatings |
| Tape Adhesive | Double-Sided, High Tack |
| Tape Dimensions | 1/4-Inch X 100 Feet or 1/3-inch x 100 Feet etc. |
| Colors | Transparent |
| Material | Polyester, Polyurethane, Metal |
| Liner | Paper / Film |
| Recommended Uses | Industrial, Construction, Electrical, Plastic |
- Enables sharp, precise cuts through tough polyurethane and polyurea coatings
- Cut from the bottom up, protecting the surface
- Fast, residue-free removal when de-masking
- Makes the process of installing a spray-on bedliner much faster and easier
Remove wax and silicone from a dirt-free surface. Then apply Wire Trim along all trim lines. For best results, notch tape to conform to tight corners and gently stretch the tape around curves.
Apply PlazMask, our pre-folded masking film, or masking paper, then scuff right up to the wire edge. Wire Trim is durable enough to withstand most prep work. Wire Trim's patented technology makes it easy to work fast. The special adhesive permits repositioning if required.
Proceed to spray the pick up truck bed just as you would normally, directly over the WireTrim tape and any other masking products you used in preparation for the spray job.
Pull the wire through the coating to provide a clean finished edge at an angle that suits your style. Choose from standard or heavy-duty wire to best suit your application. Always pull wire out as soon as possible after application.
Remove PlazMask or masking paper and tape to complete the trimming process. Our Proline products feature a high tack adhesive, remove slowly to eliminate clean up.
As a rule, Wire Trim should never leave adhesive residue behind once the tape has been removed from the vehicle. Try pulling the tape at a slower pace in order to ensure that all the adhesive remains with the tape and does not stay on the vehicle.